Blomberg DWS 54100 FBI инструкция обслуживания

Installation Manual Dishwasher FOR MODELS (ADA Height) DWS 54100 SS DWS 54100 FBI USA[...]

Installation Manual For Dishwasher Models DWS 54100 SS DWS 54100 FBI[...]

1. IMPORT ANT SAFETY INSTRUCTIONS 1 1.1 INSPECT THE DISHW ASHER 2 1.2 HOW T O CONT ACT US : 2 2. TOOLS WHICH MA Y BE NEEDED 3 3. MA TERIALS WHICH MA Y BE NEEDED 3 4. MA TERIALS SUPPLIED 4 4.1 P ARTS SUPPLIED 4 4.2 MANUAL BAG 4 4.3 DISHW ASHER P ARTS BAG 1 4 4.4 DISHW ASHER P ARTS BAG 2 4 4.5 P ARTS A TT ACHED T O THE REAR OF THE DISHWASHER 4 5. DIS[...]

1 USA     INTRODUCTION Please read this installation manual and particularly the safety instructions completely and carefully . They will save you time and effort and help to ensure optimum dishwasher performance. Be sure to observe all listed warnings and cautions. Look particularly fo[...]

2 USA • Dishwasher must be secured to adjacent cabinetry using the brackets provided. Failure to do this may cause damage to property or bodily injury . • Connect to a properly rated, protected and sized power supply circuit to avoid electrical overload. The dishwasher is designed for an electrical supply of 120 V (volts), 60 Hz (hertz), [...]

3 USA 2. TOOLS WHICH MA Y BE NEEDED 3. MA TERIALS WHICH MA Y BE NEEDED (Additional materials may be required to comply with local codes) Hot W ater Supply Line - Minimum 3/8” O.D. copper tubing or metal braided dishwasher supply line. UL listed conduit connector or strain relief. T eontapeorotherpipethreadcompoundtoseal[...]

4 USA                                             4. MA TERIALS SUPPLIED 4.1 P ARTS[...]

5 USA 5. DISHW ASHER SPECIFICA TIONS 5.1 TECHNICAL FEA TURES Load capacity 8 place settings Permissible water pressure 4.35 - 145 psi (0.3 - 10 bars) Electrical connection 120 V (volts), 12 A (amps), 60 Hz (hertz) T otal power 1400 W (watts) Heater power 1240 W (watts) Notice : Because we continually strive to improve our products, we may change ou[...]

6 USA 6. ENCLOSURE PREP ARA TION 6.1 ELECTRICAL PREP ARA TION W ARNING The dishwasher is designed for an electrical supply of 120 V , 60 Hz, AC, connected to a dishwasher-dedicated, properly grounded electrical circuit with a fuse or breaker rated for 15 amperes. 6.2 PREP ARA TION FOR INST ALLING MOUNTING BRACKETS   W ARNING Dishwasher must b[...]

7 USA 6.3.1 INST ALLING THE FOOT SUPPORTS Supplied ( 4 ) If the height of the enclosure is 33 7 / 16 ” to 34 1 / 4 ” (850mm - 870mm) use short supports as shown in the figure. Supplied ( 4 ) If the height of the enclosure is above 34 1 / 4 ” (870mm) use long supports as shown in the figure.[...]

8 USA  Adjust the front foot level with the adjusting wrench to balance and raise the dishwasher to the enclosure height. Adjust the rear foot level with a screwdriver to balance and raise the dishwasher to the enclosure height. Notice : • Make sure the dishwasher is plumb and notice dishwasher can be placed with a small clearance und[...]

9 USA 6.4 PREP ARING THE W A TER CONNECTION (A) Install an easily accessible shut-off valve (not supplied) in the water supply line. All solder connections must be made before the water line is connected to the dishwasher ’s water inletvalve.W atercanalsobesuppliedtothedishwasherbyusingaexiblebraided?[...]

10 USA 6.5 DRAIN PREP ARA TION The dishwasher drain hose may be connected to the drain plumbing in one of three ways (Figure A , B , C ). Notice : • Either one of the above methods must be used or the dishwasher will not operate properly . • A hose that attaches to a sink spray can burst if it is installed on the same water line as the di[...]

11 USA  6.7 STEAM PROTECTION FOIL Steam will form inside the dishwasher during operation. At the end of the cycle, when the dishwasher door is opened, it is required to use a steam protection foil to prevent any steam from collecting on the underside of the counter top. 6.6.2 FITTING THE PROTECTION FOIL Before applying the steam protection foil [...]

12 USA 7. PLACEMENT OF DISHW ASHER INTO THE OPENING Now place the dishwasher into the opening and get ready to connect all hoses and electrical connections. CAUTION Make sure all hoses are pulled through the side opening of the cabinet, no hoses are kinked and all slack is taken out as shown in the above figure. 7.1 DRAIN HOSE CONNECTION, W A TER S[...]

13 USA 7.1.2 W A TER SUPPL Y CONNECTION W ater supply may be connected to the dishwasher in one of two ways: • With metal braided hose. • With copper tubing. 7.1.3 BRAIDED HOSE/COPPER TUBING After connections are made turn on the water supply to check for leaks. CAUTION • Hot water supply line: Use minimum 3/8” O.D. copper tubing o[...]

14 USA                    7.3 READJUSTING FOOT LEVELS Now that the dishwasher is in the cabinet you must readjust the feet to bring the dishwasher up to the required height and attach it underneath the countertop. 1. Readjust the front foot levels with adju[...]

15 USA                     Lock the toe kick brackets as shown with the plastic tab in the figure C by pushing the plastic tab on the dishwasher into the teeth of the bracket ( C ). 3. Now attach the toe kick to the bracket with the two (Ø 3 / 16 ” x 1 / 4 ” - Ø 4mm x 6mm) screws and[...]

16 USA                7.5 INST ALLING THE OUTER DOOR (DWS 54100 FBI) Measure the height and width of the enclosure (Figure A ) and the toe kick. Determine how big the wooden door can be[...]

17 USA            5. Attach the two mounting brackets to the wooden door with 4 screws (Ø 1 / 8 ” x 5 / 8 ” (Ø 3.5mm x 14mm) (Figure A ). 6. Mount the wooden door onto the dishwasher with the plastic mounting brackets which you have attached (Figure B ).   4. Place the plastic mou[...]

18 USA                   7. Open the door and remove the two caps and two screws inside the door at position 1 and 3 (Figure C ). 8. Using the four screws Ø 3 / 16 ” x 1 11 / 16 ” (Ø 4mm x 43mm) provided, attach the wooden door to the d[...]

19 USA     1 1. Check whether the bottom of the door hits the toe kick of the kitchen cabinet ( A ). 1 1.1. If the door hits the toe kick cut the necessary section out of the toe kick ( B ). 1 1.2. Apply silicon or sealant to the cut edge of the kitchen cabinet toe kick or paint so it does not absorb moisture. ADJUSTING DOOR TE[...]

20 USA                                  Notice : If you have a European kitchen or want to install a wooden toe kick to match your kitchen, please refer to one of the two dr[...]

21 USA 8. INST ALLER CHECKLIST Y our installer must have completed and checked the following: • The dishwasher is square and level. • The dishwasher is fastened securely to the cabinetry . • The dishwasher door opens and closes freely . The dishwasher door must close without hitting any cabinetry or counter top. • The inlet wate[...]

17 9872 01 00-AA- USA[...]