BTC BCO5232IM инструкция обслуживания

Combo Drive CD-R 52X/CD-RW 32X/DVD 16X User’s Manual[...]

CAUTION CLASS 3B VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN. AVOID DIRECT EXPOSURE TO BEAM. VORSICHT KLASSE 3B SICHTBARE UND UNSICHTBARE LASERSTRAHLUNG WENN GEOFFNET. NICHT IN DEN STRAHL SEHEN. ATTENTION RADIATION DU FAISCEAU LASER VISIBLES ET INVISIBLES DE CLASSE 3B EN CAS D'O UVERTURE. EVITER TOUTE EXPOSITION AUX RAYO NS. Copyright Stat[...]

FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following tw o conditions: 1. This device may not c ause harmful interference. 2. This device must accept any interfer ence received, includi ng interference that may cause undesired operation. FCC Warning Statement This equipment has been teste[...]

Table of Contents INTRODUCTION 1 F EATURES 1 S YSTEM R EQUIREM ENTS 2 P ACKA GE C ONTENTS 2 INSTALLATION 3 H OST I NTERFACE C ONNECTIONS 3 H ARDWA RE I NSTA LLATION 4 D RIVER I NSTALLA TION 6 F OR W INDOWS E NVIRONM ENT 6 S OFTWARE D ESCRIPTION 6 DVD R EGION C ODING 7 OPERATION & CONNECTION 9 F RONT P ANE L 9 R EAR V IEW 10 TECHNICAL DATA 11 TR[...]

COMBO DRIVE 1 INTRODUCTION Features Welcome to a multimedia world of CD-ReWritable technology and DVD-ROM capabilities. This high-performance combo drive combines CD-RW and DVD- ROM in one single drive which frees up precious bay space and presents you abundant function. It reads CDs of a ll types at maximum 52X speed, and DVD-ROMs at 16X speed max[...]

COMBO DRIVE 2 System Requirements For IBM compatible PCs, the sy stem requirements recommended are as follows: ♦ PC sufficient to run Windows 98/ME/2000/XP ♦ Pentium II, Celeron 400MHz & above with at least 64MB of memory ♦ Fast and sufficient hard disk space (minimum 200MB for installation, 1GB or more is recommended.) ♦ IDE host inter[...]

COMBO DRIVE 3 INSTALLATION Host Interface Connections Most current mainboard models have two IDE ports (primary and secondary) which can connect two IDE cables. Two IDE cables allow you to connect up to four devices , but it is recommended that you separate IDE ports for your hard driv e and your Combo drive. This will ensure that your hard drive?[...]

COMBO DRIVE 4 MAST ER CSEL SLAVE JUMPER Improper or conflicting setting will c ause the unit not detected by your system. Hardware Installation 1. Turn off the power to your computer system and all peripheral devices. 2. Disconnect all cables and connectors from the back of your computer, and then remove the cover from the computer. 3. Insert the C[...]

COMBO DRIVE 5 5. If you have a sound card that can be connected to this drive, you can also connect the drive (as Audio-Out) and the sound card (as Audio-in) with a 4-pin audio cable. T o M /B Interface If your mainboard is integrated wi th built-in sound system, plug the 4-pin audio cable into the CD-IN connector on the mainboard as Audio-in. 6. R[...]

COMBO DRIVE 6 Driver Installation For Windows Environment This Combo Drive is a PnP device, and Windows 98/ME/2000/XP can automatically detect the drive and load the appropriate driver. Software Description Burning Software The bundled mastering software gives you the complete solution for making audio/data CDs right from your desktop. It allows yo[...]

COMBO DRIVE 7 DVD Region Coding Region Playback Control Management All DVD Video Playback systems have “Region Playback Control” management (RPC) which is required by Hollywood movie industry and defined by DVD Forum. This in cludes DVD-Video players and PC systems with DVD-Video capability. You can only play DVD-Video discs with the same regio[...]

COMBO DRIVE 8 About This Combo Drive This Combo Drive is a RPC2 drive and according to DVD-Forum, PC chip must be designed into DVD-ROM dr ives to record how many times a user has changed the region code. Once the limit of 5 changes is reached, the drive won't allow you to change the region code any more. It means the code will be locked and o[...]

COMBO DRIVE 9 OPERATION & CONNECTION Front Panel 12 3 4 1. Led Indicator Green LED for CD/DVD family discs. Orange LED for data writing. While the tray goes in/out, the indicator lights Green and it’s off when the drive is ready. The indicator flashes Green when the drive is reading an audio/data CD. 2. Disc Tray This is the tray for the disc[...]

COMBO DRIVE 10 Note:  The design of front panel is s ubject to change without notice. Rear View 1. Digital Audio Output Connector If your sound card has a digital audio IEC958 format connector, you can connect it to this digital audio output connector with a 2-pin audio cable. 2. Analog Audio Output Connector This connector allows you to connect[...]

COMBO DRIVE 11 TECHNICAL DATA Performance Transfer rate Read: CD-ROM: 7800kb/sec (up to 52X) CD-RW: 6000kb/sec (up to 40X) DVD-5: 21632kb/sec (up to 16X) DVD-9: 13520kb/sec (up to 10X) Write: CD-R: 7800kb/sec (up to 52X) CD-RW: 4800kb/sec (up to 32X) Data buffer 2MB Writing modes TAO (Track at once), DAO (Disc at Once), SAO (Session at once), Multi[...]

COMBO DRIVE 12 Disc Disc Size 80mm and 120mm discs Disc Data Capacity DVD-ROM: Single layer – 4.7GB Double layer – 8.5GB (one side) CD-ROM: 74min – 650MB – Mode 1 80min – 700MB – Mode 1 Disc Format Supported Write Read CD-DA   CD-ROM   CD-ROM XA   CD-EXTRA   Video CD   Photo CD   CD-I   CD-TEXT [...]

COMBO DRIVE 13 TROUBLESHOOTING To help you get more familiar with t he Combo Drive, the following FAQ lists some common problems you might encounter. Please read it for reference before you request RMA support from your dealer. Q1. The drive cannot be recognized. (1) It’s possible the drive hasn’t been connected properly. Please check whether t[...]

COMBO DRIVE 14 Q5. The drive can’t read former session(s) of the CD-R disc which has been w ritten tw ice or more times. Before writing CD-R discs with data copy, remember to choose “Import session” so as to read the former sessions. Q6. There is noise w hile reading. If the disc used is eccentric or there are labels stuck on the di sc surfac[...]

COMBO DRIVE 15 (2) More capacity of hard disk is needed if using hard disk as temporary buffer. (3) Place the disc correctly. (4) The blank disc needs full format first if using packet writing software. Q11. “Buffer underrun” alw ays occurs while w riting discs. Here are some suggestions: (1) Close the screen saver & TSR (Terminate and Stay[...]

3100552470 Version 1.0 June 2004[...]