Craftsman 358.74824 инструкция обслуживания

Instruction Manual J CRRFT$1VlRN°I 12 AMP Motor 220 MPH/360 CFM ELECTRIC BLOWERNACUUM Model No. 358.748240 • Safety • Assembly • Operation • Maintenance • Espar_ol FOR HOUSEHOLD USE ONLY WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions about this product,[...]

Warranty Statement 2 Parts Available 10 Safety Rules 2 Storage 11 Assembly 5 Troubleshooting Table 11 Operation 8 Maintenance 9 Spanish 12 Service & Adjustments 10 Parts Ordering Back Cover FULL TWO YEAR WARRANTY ON SEARS CRAFTSMAN ELECTRIC BLOWER If this Craftsman Electric Blower fails to perform properly due to a defect in material or workman[...]

ELECTRICAL SAFETY AWARNING: Avoid a dangerous environment. To re- duce the risk of electrical shock, do not use in rain, in damp or wet locations, or around swimming pools, hot tubs, etc. Do not expose to snow, rain, or water to avoid the possibility of electrical shock. Do not use on wet surfaces. Do not handle extension cord plug or unit with wet[...]

insulation construction consists of two separate "layers" of electrical insula- tion instead of grounding. Tools and appliances built with a double insulation system are not in- tended tobe grounded. No grounding means is provided on this unit, nor should a means of grounding be add- ed to this unit. As a result, the exten- sion cord used[...]

• Never use for spreading chemicals, fertilizers, or any other substances which may contain toxic materials. VACUUM SAFETY • Stop the motor and disconnect the power source before opening the air inlet door or attempting to insert or re- move the vacuum tubes. The motor must be stopped and the impeller blades no longer turning to avoid seri- ous[...]

2. Push the blower tube onto the blower outlet until itsnaps into place (tube is secured by red tube release button). 3. To remove the blower tube, press the tube release button while pulling on tube. i_¢_)TubeRelease Button .z B,owe Tube VACUUM ASSEMBLY NOTE: Assembly instructions for using your unit as a blower are explained in the previous sect[...]

Elbow Tube Tube Release Button Hole Zipper _1 Opening Opening 3. Close the zipper on the bag. Make sure the zipper is closed complete- ly. 4. Align the grooves on the elbow tube with the grooves on the blower outlet. 5. Push the elbow tube onto the blow- er outlet until it snaps into place (el- bow tube is secured by red tube re- lease button). ADJ[...]

MINIMUM WIRE GAUGE RECOMMENDATIONS 100 FT. A.IW4G.* *American Wire Gauge Secure the extension cord to the unit by threading the cord through the cord re- tainer (see illustration). Insert the cord receptacle into the recessed plug. CAUTION: Failure to use cord retain- er could result in damage to the unit, extension cord, or both. Cord Receptacl_ ?[...]

z_ 4rLWARNING: You MUST make sure the tubes are secure before using the unit. _WARNING: Do not use the unit without the tubes or collection bag prop- erly attached to avoid flying debris and/ or impeller contact which can cause se- rious injury. Always wear eye protection to prevent rocks or debris from being blown or ricocheting into the eyes and [...]

GENERAL RECOMMENDATIONS The warranty on this unit does not cover items that have been subjected to oper- ator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instructed in this manual. Various adjustments will need to be made periodically toproperly maintain your unit. BEFORE EACH USE CHECK FOR LOOSE[...]

dlI_WARNING: Perform the follow- ing steps after each use: • Stop unit and disconnect from the power source. • Allow motor to cool before storing or transporting. • Store unit with all guards in place• Position unit so that any sharp object cannot accidentally cause injury. • Store unit unplugged, well out of the reach of children. SEASON[...]