Fisher & Paykel HS60CSW1 инструкция обслуживания

Slideout rangehood Installation instructions and user guide NZ AU HS60CSW1, HS60CSX1, HS60CIW1, HS60CIX1 models[...]

Safety and warnings 1 Installation instruc tions 2 Getting started quickly 6 Cleaning and maintenance 7 Manufacturer ’ s warranty 8 Customer care 9 Con tents Impor tant! SA VE THESE INSTRUCTIONS The models shown in this user guide may not be available in all markets and are subject to change at any time. For current details about model and specif[...]

1 Impor tant! Please read the entire set of instructions before installing the rangehood. This rangehood is not intended for use by young children or infirm p ersons without super vision. Y oung children should be super vised to ensure that they do not play with the rangehood. There must b e adequate ventilation of the room when the rangehood is us[...]

2 Installation instructions Thank you for purchasing a qualit y Fisher & Paykel rangehood. Each rangehood is tested and approved befor e it leaves the factory, ensuring our high standard of quality control is met. Cont ents of packaging 1 x rangehood 1 x installation instruc tions 4 x Spacer T ube 25.4 mm 4 x Screw 8x1.5” 4 x Screw 8x1” T y[...]

3 Installation instructions Height of rangehood Please read the entire instructions BEFORE installing the rangehood. Ascertain the desired installation height of the rangehood. When installing the rangehood, the lower edge of the unit must be a minimum of 600 mm (650 mm for gas cooker) above the cook ing sur face. The recommended position for the h[...]

4 Installation instructions Preparing the rangehood for installation Ensure the overhead cabinets are built according to Fig.5 (below). Before drilling any holes, check that the area behind the sur face to be drilled is clear of any electrical cables or pipes etc. Recirculating If the rangehood is to be installed as a recirculating hood, the knocko[...]

5 Mounting to cabinetry sides Fix rangehood to your wall units, with 2 screws in each side into the vertical panels. T o do this: 1 Slide out the drawer and remov e filter . Y ou will see t wo mounting holes running through the moulded sides. 2 Remove thin plastic skin (A) from each side fixing hole (see F ig.7). An 8 mm diameter drill bit is recom[...]

6 Getting star ted quick ly Fig .9 Control panels Light switch: the light can be operated independently from the fan. Fan switch: the fan can be run at different speeds depending on the cooking requir ements. 2 speed Axial fan switch HS60CSX1, HS60CSW1 3 speed Centrifugal switch HS60CIX1, HS60CIW1 Contr ol panel features[...]

7 Caution! Never use abrasive or oil based liquid cleaners. General maintenance The manufacturer is not liable for any damage caused by not following these instructions. The rangehood should be cleaned regularly using warm water with soap or mild liquid detergents . This ensures that no build-up of grease occurs as these deposits are corrosive. Do [...]

8 When you purchase any new Fisher & Pa ykel rangehood you automatically receive a two year Manufacturer ’ s W arranty cov ering par ts and labour for servicing. Fisher & Paykel under takes to Repair or , at its option, replace without cost to the owner either for material or labour any par t of the Product, the serial number of which app[...]

9 Check the things you can do yourself . Refer to your User Guide and check: 1 Y our appliance is correc tly installed. 2 Y ou are familiar with its normal operation. If after check ing these points you still need assistance, please refer to your nearest Authorised Ser vice Centre, or contact us through our local website listed on the back cov er .[...]

Copyright © Fisher & P aykel 2008. All rights reserved. The product specifications in this book let apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement , these specifications may change at any time. Y ou should therefor e check with your Dealer to ensure this booklet corr[...]