Haier DW12-LBE инструкция обслуживания

Dishwasher DW12-LBE Instructions for Use 012050 en[...]

Safety Is a Good Habit to Develop Close-up View (Control Panel) NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. This appliance complies with the following EEC di- rectives: -73/23/EEC of 19 February 1973 ([...]

.2. Close-up View (Interior) A B C D E Upper Rack Rack Height Adjustor Top Spray Arm Lower Rack F G H I Washing Filter Bottom Spray Arm Detergent and Rinse Aid Dispenser Third Sprayer Specifications Width Depth Height Capacity Mains Water Pressure Power Voltage Total Absorber Power Salt Container Cap GB 60cm 58cm 82cm 12 standard place settings 0.0[...]

.3. Salt      Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading the Salt into t[...]

.4. Detergent and Rinse Aid      Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table." The detergent dispenser is located on the inside panel of the door[...]

.5. Loading the Dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washed. This will eliminate the need for extra wa[...]

Starting the Appliance Starting a wash cycle      After having completed all of the installation steps in the preced- ing paragraphs, turn on the water all the way and press the ON- OFF button (A) located on the control pannel. The appliance is on. Cancelling or modifying a cycle A cycle that is underway can only be modified if it ha[...]

.7. - It is important to try and run the dishwasher when it is fully loaded in order to save on energy. To prevent odours from form- ing and food from caking onto the dishes, you can run the soak cycle. - Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are. Ener[...]

.8. Wash Cycle Table GB Cycle Selection Information Description of Cycle Detergent Rinse Aid Normal dirty dishes, pots and pans. standard daily cycle. Very dirty dishes, pots and pans. (not to be used with deli- cate items) Pre-wash with cold water. Extended wash at 55 ° C. Rinse with cold water. Rinse with hot water . Drying. Short cold wash to p[...]

.9. GB Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is advisable to remove the larger food particles trapped in the filter after each wash [...]

Fig.2 Fig.1 .10. Installation Drain Hose Connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to avoid bending or crimping it. Use the special plastic support that comes with the appliance (see Fig.2). The free end of the hose must be at a height between 40 and 100 cm and must n[...]

A.Wiring box B.Door switch C.W ater level switch D.Drain motor E.Overflow switch F .Half wash switch G.Softer valve H.Dispenser valve I.Aquastop inlet valve J.W ashing motor K.T emperature limiter L.Heater M.Relay N.Sensor temperature O.Salt missing switch P .Rinseing aid missing switch P O N M L K J I E G F H D C B A S 2 C ML 1 4 M 1 AQS 2 3 1 IAQ[...]