Hayter Mowers 447E инструкция обслуживания

Operator ’ sManual R48 Recycling Mower G008079 Code 445E, 446E, 447E Serial No. 280R00001, 280S00001,or 280T00001 and Up Manual Part No. 1 1 1-2087 Rev B[...]

Introduction R ead this infor mation carefully to learn ho w to operate and maintain your product properly and to av oid injur y and product damage. Y ou are responsible for operating the product properly and safely . Whenever you need ser vice, g en uine par ts , or additional infor mation, contact an A uthorized Service Dealer and hav e the model[...]

Safety Improper ly using or maintaining this mower can result in injur y . T o reduce the potential for injur y , comply with these safety instr uctions. This mow er was designed and tested for reasonably safe ser vice; howev er , failure to comply with the following instr uctions ma y result in personal injury . T o ensure maximum safety , best pe[...]

– Do not mow ex cessi v ely steep slopes . – Exercise extreme caution when on slopes . – Mow across the face of slopes , never up and down and exercise extreme caution when changing direction on slopes . – Alwa ys be sure of your footing on slopes . • Use lo w throttle settings when engaging the traction-clutch, especially in high gears .[...]

Safety and Instructional Decals Important: Safety and instr uction decals are located near areas of potential danger . Replace damaged decals. Manufacturer ’ s Mark 1. Indicates the blade is identied as a part from the original machine manufacturer . 1 10-7058 1. Height of cut 1 10-7059 Model 447E only 1. Read the Operator ’s Manual. 4. Inst[...]

Setup Unfolding the Handle 1. Unlock the handle locks , mov e the handle sections into the operating position, and lock the handle locks (Figure 3). Figure 3 2. Unlock the upper handle loc ks and rotate the upper handle upward and lock it into a position that is comfortable to you (Figure 4). Figure 4 1. Highest position 3. Lowest position 2. Middl[...]

Installing the Fuse (Model 447E Only) Y our mo wer comes with a 40-amp fuse that protects the electric star ter . Important: Y ou cannot start the mower with the electric star ter or charge the batter y unless y ou install the fuse. 1. R emov e the battery co ver and the battery and locate the fuse holder (Figure 7). Figure 7 1. Screw 3. Fuse holde[...]

Product Overview G008078 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Figure 9 Model 447E shown 1. Lower handle lock 9. Oil ll/Dipstick (not shown) 2. Grass bag 10. Fuel tank cap 3. Upper handle lock 1 1. Cutting height lever (2) 4. Recoil start handle 12. Spark plug 5. Upper handle (Models 446E and 447E only) 13. Primer 6. Blade control bar 14. Air l[...]

detergent oil with an API ser vice classication of SF , SG , SH, SJ , SL, or higher .) 3. Install the dipstic k. Adjusting the Cutting Height Adjusting the cutting height may bring y ou into contact with the moving blade, causing serious injur y . • Stop the engine and w ait for all moving par ts to stop . • Do not put y our nger s under [...]

Figure 15 4. If the mower does not start in 1 or 2 pulls (or within 5 seconds using the electric starter), press the primer button 1 or 2 times and try starting it again. Note: If the mower still does not star t, contact an Authorized Ser vice Dealer . Using the Self-propel Drive (Models 446E and 447E Only) T o operate the self-propel dri ve , simp[...]

T o bag the grass clippings , install the grass bag (refer to Installing the Grass Bag) and mo v e the R ecycling/bag ging lev er to the bagging mode (Figure 18). Installing the Grass Bag Raise and hold up the rear door , install the bag, and low er the rear door (Figure 19). G008083 Figure 19 Removing the Grass Bag T o remo v e the bag, rev erse t[...]

W et grass or leav es can cause serious injur y if y ou slip and contact the blade. Mow only in dr y conditions. • Alternate the mowing direction. This helps disperse the clippings o ver the lawn for even fertilization. • If the nished la wn appearance is unsatisfactory , tr y one or more of the follo wing: – R eplace the blade or ha v e i[...]

Maintenance Recommended Maintenance Schedule(s) Maintenance Service Interval Maintenance Procedure After the rst 5 hours • Change the engine oil. Before each use or daily • Check the engine oil level. • Ensure that the engine stops within 3 seconds after releasing the blade control bar . • Clean the mower . Every 25 hours • Charge the [...]

Lubrication Lubricating the Wheel Gears Ser vice Inter v al: Y early—Lubricate the wheel gears . 1. R emov e the wheel bolts on the rear wheels and remov e the rear wheels . 2. Apply a lubricating oil to the gear as sho wn in Figure 22. Figure 22 3. Install the rear wheels . Engine Maintenance Replacing the Air Filter Ser vice Inter v al: Y early[...]

Figure 24 4. Slowly pour oil into the oil ll tube until the oil level reaches the Full line on the dipstic k (Figure 6). Do not o v erll. (Max. ll: 0.59 l, type: SAE 30W detergent oil with an API service classication of SF , SG , SH, SJ , SL, or higher .) 5. Install the dipstick securely . 6. Dispose of the used oil properly at a local [...]

Drive System Maintenance Adjusting the Self-propel Drive If y our mo wer does not self-propel properly , adjust the self-propel driv e cable. 1. Loosen the n ut on the cable mount (Figure 26). Figure 26 1. Nut on cable mount 2. Pull the upper handle bac k fully rearw ard (Figure 27). Figure 27 3. Pull the cable jack et downward until you remov e th[...]

Blade Maintenance Replacing the Blade Ser vice Inter v al: Ev ery 25 hours—R eplace the blade or hav e it sharpened (more frequently if the edge dulls quic kly). Important: Y ou will need a torque wr ench to install the blade pr oper l y . If y ou do not ha ve a torque wrench or are uncomfor ta ble perfor ming this procedure, contact an Authoriz [...]

Cleaning Cleaning the Mower Ser vice Inter v al: Before each use or daily—Clean the mow er . Tipping the mo wer may cause the fuel to leak from the carburetor or the fuel tank. P etrol is extremely ammable, highly explosi ve, and under certain condition can cause per sonal injur y or proper ty damage. Run the engine dr y or remov e the fuel wi[...]

Notes: 19[...]

Notes: 20[...]

1st Y ear (12 months) W e certify that this service has been carried out by an Authorised Hayter Service Dealer Date: 1st Y ear (12 months) Owner’s Name: Serial Number: Date: 2nd Y ear (24 months) W e certify that this service has been carried out by an Authorised Hayter Service Dealer Date: Owner’s Name: Serial Number: Date: Note for dealer : [...]

[...]

LIMITED WARRANTY Hayter Limited warrants to the original user/purchaser that this unit shall be free from defects in material and workmanship under normal use and service for a period of three years from the date of purchase. The manufacturer of major proprietry components ie. engines, gearbox / transaxle (where applicable) furnish their own warran[...]

CUS T OME R INFO RMA TI ON Date of Sale:- Y our Local Dealer:- HA Y TER L IM ITED , SPEL L BR OO K, BI SHOP ’S S T OR TF ORD , H E R T S . C M 23 4B U, E N G L A N D Code Serial No.[...]