Lennox Hearth SWI210 инструкция обслуживания

INST ALLA TION AND OPERA TION MANUAL W ARNINGS • Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. • Carefully supervise children in the same room as appliance. Save These Instructions For Future Reference A F ren c[...]

2 CO N GR A TU L A TI ON S ! When you purchased your new wood-burning fireplace insert, you joined the ranks of thousands of individuals whose answer to their home heating needs reflects their concern for aesthet- ics, efficiency and our environment. We extend our continued support to help you achieve the maximum benefit and enjoyment available[...]

3 1. When this room heater is not properly installed, a house fire may result. T o reduce the risk of fire, follow the installation instructions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. 2. Wear gloves during installation to avoid injury from sharp edges on the insert and[...]

4 This manual describes the installation and operation of these non-catalytic wood heaters. These heaters meet the U.S. Environmental Protection Agency’ s emissions limits for wood heaters sold on or after July 1, 1990. This heater has been developed, tested and constructed in accordance with the requirements of UL 1482, ULC S628 and HUD standard[...]

5 Dry , seasoned wood is that which has been cut, split and allowed to dry under a covered area where air is free to flow and circulate under and around the wood (not under a tarp or plastic). Make sure wood is not stacked directly on the ground, it may absorb moisture from the ground. It should be allowed to dr y in these conditions for a minimum[...]

6 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. CAUTION: Wear gloves during brick installation in case of sharp edges behind the fireplace insert. Note: Installation of the baffle boards and baffle blankets are easier when you can still access the flue outlet, (before connecting the flue vent). Be sure the baffle blankets are placed ?[...]

7 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. C/A210 SWI210 ZC Fireplace UL 127 Masonry Fireplace UBC Chapter 37 Depth Min. 12-1/2” (318mm) 12-1/2” (318mm) Height Min. 21” (533mm) 19-1/4” (489mm) Width Min. 36” (914mm) 26” (660mm) Lintel Max. Depth u 4-1/2” (114mm) 4-1/2” (114mm) u Without use of adjustable offset box or s[...]

8 The hearth and/or floor protection must be a thermally rated non-com- bustible hearth/floor protector meeting or exceeding a thermal rating of k=.84 or equivalent with a listed thickness of 3/8" (9.5mm) minimum in USA (3/4" - 19mm minimum in Canada). The covering must extend 18” (450mm) in front of the heater and 8” (200mm) to eit[...]

9 CHIMNEY REQUIREMENTS This appliance is approved for use in a masonr y fireplace built to UBC Chapter 37 or equivalent with a minimum 26” (660 mm) opening at the front of the fireplace. Thes e heate rs are desig ned to be instal led into an exis ting masonry firepl ace (built to UBC 37 or ULC S628 standards) or factory-built, solid-fuel and w[...]

10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. A positive flue connection is providing a seal between the vent pipe or liner and the existing fireplace chimney for the purpose of preventing room air passage to the chimney cavity of the fireplace. There are dif- ferent approved methods to achieve this. See Direct Connect Positive Flue C[...]

11 Fireplace and Chimney Requirements This appliance must only be installed in a zero clearance factor y-built fireplace using 6” (152mm) stainless steel pipe extending from the insert’ s flue into the chimney of the fireplace. For optimum safety and performance we recommend a full length stainless steel liner directly connected to the inser[...]

12 Place the insert into the fireplace, making sure to center it side to side. Slide the insert in until the surround mounts are approximately 1/2” (13 mm) from the face of the fireplace where the surround panels cover . Lower the chimney and make attachment to the insert. Level the fireplace insert by using a 3/4” socket and a long extensio[...]

13 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Be sure to clean plated accessories with a household type cleaner and a ver y soft cloth to remove any fingerprints and residues prior to the first fire. 1. NEVER USE FLAMMABLE LIQUIDS TO ST ART OR REKINDLE A SOLID FUEL FIRE!! 2. Fully open the primar y draft control by pulling the 1” pl[...]

14 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. W ARNINGS The blower must be plugged directly into a properly grou nded three -pro ng rec epta cle, 120 V AC, 60 Hz, sin gle phase. Do not cut or remove the grounding prong from this plug. Do not route power cord under or in front of appliance. Installation must be in accordance with National[...]

15 Recen t developmen ts in wood-b urnin g techn ology have made wood-bur n- ing a clean er and more conve nien t way to heat your home. Over all efficie ncy in a wood-burning appliance is a combination of combustion efficiency and heat transfer efficiency . Whether heating your entire home or just a room or two, your understanding of how to bes[...]

16 MAINTENANCE DOOR HINGES: If door hinges need lubricating, use an anti-seize com- pound (never use oil) available from your Lennox Hearth Products dealer . DOOR LA TCH: If your door latch fails to latch tightly and the gasket is in good condition, place a length of pipe (cheater bar) over the inside portion of the door handle and bend slightly to[...]

17 Problem Solution POOR DRAFT : Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember , the fireplace inserts’ draft depend solely on the natural draft of the chimney (See Draft Requirements on Page 4 ) . If your fireplace insert is not drafting properly , your c[...]

18 DO NOT : Install or operate this fireplace insert before reading this manual. DO NOT : Close the draft beyond the point at which the flames are completely extinguished. DO NOT : Open the fireplace insert door without fully opening the draft first. DO NOT : Burn driftwood or wood that has been in salt water . This includes some mill ends and [...]

19 FRONT DOOR P ARTS LIST Item # Cat . N o . De scr i pt ion 1 H5639 Door Rope Kit, 7/8” Dia. (6’ 2”) 2 H5629 Upper Hinge Pin 3 H5626 Upper Hinge Pin E-Clip 4 H5628 Lower Hinge Pin 5 H5646 Lower Hinge Pin Copper Washer 6 H5640 Glass Gasket Kit (8’ 4”) 7 H5577 Set of 6 screws and 6 washers for door assembly 8 H5654 Spring Handle / Nickel H[...]

20 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 33 34 36 36 45 46 47 37 37 35 40 44 40 38 38 38 41 38 38 38 41 38 38 42 38 38 38 38 42 38 38 39 39 43 39 39 REPLACEMENT P AR TS - MODELS C210, CA210 AND SWI210[...]

21 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. 7 13 1 2 3 4 5 6 8 1 2 3 4 5 9 10 8 14 11 6 7 12 16 29 17 15 32 18 19 REPLACEMENT P AR TS - MODELS C210, CA210 AND SWI210 Door Parts Blower Parts[...]

22 Product Reference Information Ca t. N o. De scr i pt ion S hip . W e ig ht Sh ip. V ol um e H 7 8 9 1 C 2 1 0 T -B , I n s e rt / T ra di ti o n a l Bl a c k D o o r / N i c k e l N a m e p l at e 4 2 7 l b . 1 8 . 3 0 c u . f t . H 7 8 9 2 C 2 1 0 A - B , I n s e rt / A r c h Bl a c k D o o r / N i c k e l N a m e p l a t e 4 2 6 l b . 1 8 . 3 [...]

23 SAFETY / LISTING LABEL - MODELS C210, CA210 AND SWI210 2011 201 2 2013[...]

24 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775212M Rev . C 09/2011 Y our Appliance?[...]