Miele CS 1322 инструкция обслуживания

Operating and Installation Instructions Electric Barbecue CS 1322 To prevent accidents and machine damage, read the Operating Manual before installation or use. M.-Nr. 07 374 400 e n-C A[...]

IMPORTANT SAFETY INSTRUCTIONS .................................3 Description of the unit ..............................................7 Before using for the first time ........................................8 Use .............................................................9 Prepare the appliance ...............................................9 T[...]

WARNING- When using your appliance follow basic precautions, including the following: Read all instructions before installation or use to prevent injury and appliance damage. This appliance conforms to all uniform safety codes and regulations. The manufacturer cannot be held responsible for damage or injury caused by improper use of this appliance.[...]

Technical Safety ~ Installation, repair and maintenance work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and may void the warranty. ~ Before installing the appliance, check for externally visible damage. Do not operate a damaged appliance. ~ To guarantee the electrical safety of this [...]

Safety ~ The appliance is hot during use and remains so for some time after being switched off. Be careful not to touch the appliance if it may still be hot. ~ Protect your hands with oven mitts or potholders when using the appliance. Use only dry, heat resistant potholders. Moist or damp potholders used on hot surfaces can result in steam burns. D[...]

~ To prevent burns and breathing difficulty, allow the appliance to cool before cleaning. Some cleaners may produce toxic fumes if applied to a hot surface. ~ When wiping spills on a hot appliance with a wet sponge or cloth, be careful to avoid steam burns. ~ Do not let flammable materials, i.e. cooking grease, accumulate on the appliance. ~ Do not[...]

a Grates b Heating element, front c Heating element, rear d Lava rock container e Drain valve f Cooking area indicators g Display Control knobs: h front i rear Display j On/Off indicator Description of the unit 7[...]

Clean the appliance ^ Clean the water trough and the grill with a mild solution of warm water and liquid dish liquid, then dry with a soft cloth (see "Cleaning and care"). ^ Wipe the other surfaces down with a damp cloth and dry. Heat the appliance Metal components of the appliance have a protective coating which may give off a slight odo[...]

Prepare the appliance You can use the electric barbecue with or without the lava rocks. Without the lava rocks: food will stay more moist, from the rising steam. With the lava rocks: the food will have a more pronounced grilled aroma and flavor. ^ Check that the drain valve is closed. ^ Remove the grate, raise the heating element, and remove the la[...]

Grilling While grilling, watch the level of water in the trough. If necessary, add more water. Do not use aluminum dishes, pans, pots or foil on the grill. Never cover the grill grate with aluminum foil. Aluminum will cause overheating and may damage the grill grate. ^ Turn one or both operating knobs to power level "12". Pre-heat the gri[...]

Grilling times Food item Grilling time in minutes Meat and sausage Boneless steak 8 - 10 Chicken breasts 16 - 18 Cutlets 8 - 12 Filet steak 4 - 10 Hamburgers 12 - 16 Kebabs 14 - 18 Lamb chop 4 - 8 Sausages 6 - 8 Spare Ribs 15 - 20 T-Bone Steak 10 - 20 Turkey cutlet 8 - 10 Fish / seafood Salmon steak 10 - 12 Shrimp 2 - 4 Trout 12 - 16 Tuna steak 6 -[...]

Overheat protection If there is not enough water in the water trough, the overheat protection automatically switches the appliance off. ^ Pour in cold water. Once the appliance has cooled down and the heating element switches back on, you can continue grilling as normal. Safety cut-out feature The safety cut-off ensures that the heating element wil[...]

, Under no circumstances use a steam cleaner to clean this appliance. Pressurized steam could cause permanent damage to the surface and to components for which the manufacturer cannot accept responsibility. Never use strong cleaners e.g. oven sprays, stain or rust removers. Scouring pads and abrasive cleaning agents should only be used on the heati[...]

Lava rocks Clean the lava rocks on a regular basis. To do so, put the rocks in a container with mild solution of warm water and liquid dish soap. Let them soak briefly, stirring occasionally. Drain water and rinse rocks. Repeat this process 2 to 3 times with fresh water. Lay the rocks on a large kitchen towel to dry. Clean the pumice stones to remo[...]

, Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The manufacturer cannot be held responsible for unauthorized work. What if the appliance does not heat up after it is turned on? Possible fault Solution The overheat [...]

In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting Technical Service please quote the serial number and model of the appliance. This information is visible on the silver data plate supplied with the appliance. Technical Servi[...]

Miele offers a variety of additional accessories for its appliances. All accessories can be ordered from Miele. Griddle CSGP 1400 Cast grill plate, with one smooth side and one ridged side, for CS 1322 Wire rack for Griddle Plate CSGP1400 Handle Stainless steel and ceramic surface cleaners Help to remove soiling, lime spots, mild staining, fingerpr[...]

18[...]

Installation Instructions IMPORTANT: SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE To prevent accidents and machine damage read these instructions before installation or use.[...]

Note to the installer: Please leave this instruction book with the consumer for the local electrical inspector’s use. The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire. The cabinetry and venting hood should be installed first to prevent da[...]

Safety distances above the appliance The minimum safety distance given by the hood manufacturer must be maintained between the grill and the hood above it. See the installation instructions of the hood for these safety measurements. If the hood manufacturers instructions are not available or if flammable objects are installed over the grill (e.g. c[...]

Safety distances to the sides of the appliance The appliance should only be installed as shown in the illustrations while maintaining the required safety distances shown. Do not install the appliance between two tall cabinets, this is a fire hazard. A distance of at least 2" (50 mm) must be kept between the countertop cut-out and the rear wall[...]

Safety distance when installing the appliance near a wall with trim or a back splash A minimum distance of 2" (50 mm) between the trim or back splash and the countertop cut-out if required. This distance is only necessary if these items are made of combustible materials e.g. wood. If the trim or back splash is made of a non-combustible materia[...]

Installation dimensions a Spring clips b Appliance front c Installation height d Power supply box with connection cable ,L=7 8 3/ 4 " (2000 mm) e Drain valve Installation 24[...]

Cut out ^ Make the worktop cut-out for one or more appliances as applicable. Remember to maintain a minimum safety distance from the back wall , as well as from any tall unit or side wall to the right or left of the appliance(s). See also "SAFETY INSTRUCTIONS FOR INSTALLATION". ^ Seal the cut surfaces with a suitable sealant to avoid swel[...]

Installation of multiple appliances When installing more than one combiset appliance, a support bar b must be installed between the appliances. Countertop cut-out two appliances For the installation of two appliances the width of the countertop cut-out D is the sum of A and C. A , B and C = appliance widths 11 5 / 16 ", 15" or 22 11 / 16 [...]

Sample calculations for a countertop cut-out for three appliances A appliance width minus 5 / 16 "( 8m m ) B appliance width C appliance width minus 5 / 16 "( 8m m ) D Countertop cut-out 11" (280 mm) 11 5 / 16 " (288 mm) 11" (280 mm) 33 3 / 8 " (848 mm) 11" (280 mm) 15" (380 mm) 14 5 / 8 " (372 mm) 40 5 [...]

a Spring clips b Support bars c Space between support bar and countertop An additional support bar is required for each additional appliance. The position for attachment of an additional spacing strip depends on the width of the appliance B . Installation 28 A B C b a a D a a a a (280/372/568mm) c c (25-30mm) 3/16" 1"-1 (500 m m ) + - 1 2[...]

Attach the spring clips and support bars Wood or solid surface countertops ^ Place the supplied spring clips a and the support bars b at the marked positions as shown above, by laying them on the upper edge of the cut-out and then securing them with the 1 / 8 " x 1" (3.5 x 25 mm) screws (supplied). Granite countertop ^ Position and attach[...]

^ Coat the edges of the spring clips a , ^ and the space d between the strips b and the countertop with silicone (supplied). Installation 30 b d a[...]

Installing the appliance ^ Feed the power cord down through the cut-out. ^ Then place the front side of the appliance in the countertop cut-out. ^ Then with a hand on each side of the appliance press down evenly on the edges until it clicks into position. When doing so make sure that the appliance seal sits tightly on the countertop to ensure it is[...]

Sealing The appliance must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the appliance provides a sufficient seal for the countertop. If the appliance is sealed into position, the countertop or appliance could be damaged if it needs to be removed for maintenance or service. Tiled surfaces The grou[...]

, CAUTION: Before installation or servicing, disconnect the power supply by either removing the fuse, shutting off the main power supply or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by [...]

Disposal of packing materials The cardboard box and packing materials are biodegradable and recyclable. Please recycle. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of children. Danger of suffocation! Disposal of an old appliance Old appliances contain materials that can be recycled. Please contact [...]

35[...]

Alteration rights reserved / 4608 For the most updated manual see the Miele web site. M.-Nr. 07 374 400 / 00[...]