Planar PL1702 инструкция обслуживания

PL1702[...]

1 Contents Preface ................................................. 2 Installation .............................................. 4 Unpacking ............................................................................................................................................................................... 4 Connecting the LCD Monitor an[...]

2 Preface This manual is designed to assist users in setting up and usin g the LCD Monitor. Information in this document has been carefull y checked for accuracy; however, no guar antee is given to the corre ctness of the contents. The information in this document is subject to change without notice. This do cument contains proprietary information [...]

3 Important Safety Instructions Please read the following in structions carefully. This manual should be retain ed for future use. 1. To clean the LCD Monitor screen: -- Power off the LCD Monitor and unplug the AC Cord. -- Spray a non-solvent cleaning solution onto a rag. -- Gently clean the screen with dampened rag. 2. Do not place the LCD Monitor[...]

4 Installation Unpacking Before unpacking the LCD Monitor, prepare a suitable wor kspace for your Monitor and computer. You need a stable and clean surface near a wall power outlet. Make sure that the LCD Monitor has enough space around it for sufficient airflow. Though the L CD Monitor uses very li ttle power, some ventilation is needed to ensure [...]

5 Connecting the LCD Monitor and Base When you open the box, take the base and put on the desk first. Then connect the LCD Monitor and base.(See fig.1-1 ) Figure 1-1 Viewing Angle Adjustment The LCD Monitor is designed to allow users to have a comfortable viewing angle. The viewing angl e can be adjusted from -5°to +20°. and the sw ivel angle can[...]

6 Connecting the AC Power 1. Connect the power cord to the LCD Monitor.(See Fig. 1-6) 2. Connect the powe r cord to an AC power source . Connecting the Audio Cable 1. Connect the audio cable to the “LINE OUT “ jack on your PC's audio card or to the front panel' s “AUDIO OUT” jack of your CD ROM drive. (See Fig. 1-7) 2. Connect the[...]

7 Display Controls User Controls A brief description and the location of all LC D Monitor functions controls and indicators: Figure 2-1 1 Power LED will be Green when the monitor is on, Yellow when in power saving mode, and Dark when the monitor is off. Press this button to turn on and turn off the monitor. 2 Function select (clockwise) 3 Function [...]

8 Function Description Icon Function Function Description Brightness 101 scales of brightness are availa ble to choose from (0 to 100). Contrast 101 scales of contrast are available to choose from (0 to 100). H. Position This function let's you adjust the display's horizontal position. V. Position This function let's you adjust the d[...]

9 OSD Lock Out Function When monitor is in normal display, you ca n enable the “OSD Lock Out” function. Option 1 : OSD lock – all 4 buttons are locked except the “POWER” button. Press and hold the , and buttons for same time 3 seconds to lock the buttons. The monitor will show an “OSD Lock Out” messa ge for 5~10 seconds and the messag[...]

10 Technical Information Specifications LCD Panel Size 17" (43 cm) Display Type Active matrix color TFT LCD Resolution 1280 x 1024 Display Dot 1280 x (RGB) x 1024 Display Area (mm) 337.92 x 270.336 (H x V) Display Color 16.7M (RGB 6 bits+FRC) Lamp Voltage (typical) 660 Vrms Lamp Current (typical) 7.5 mA rms. Video Input Signal Input Impedance [...]

11 Power Management Mode Power Consumption* AC Input LED Color DPM ON 48W maximum 240 VAC GREEN DPM OFF 2W maximum 240 VAC Yellow DC switch off 1W maximum 240 VAC Dark Disconnected 2W maximum 240 VAC Dark Meeting VESA DPM requirements measured from AC Input end of AC power cord. Sync Input Analogue Signal Separate TTL compatib le horizontal and ver[...]

12 Standard Timing Table If the selected timing is NOT included in table below, th is LCD monitor will use the most suitable available timing. SYNC TOTAL ACTIVE SYNC FRONT BACK PIXEL TIMING FH(kHZ) FV(HZ) POLARITY (DOT/ LINE) (DOT/ LINE) WIDTH (DOT/LINE) PORCH (DOT/LINE) PORCH (DOT/LINE) FOREQ (MHZ) 640x350 31.469 + 800 640 96 16 48 25.175 VGA-350 [...]

13 1280x960 60.00 + 1800 1280 112 96 312 108.00 (60Hz) 60.00 + 1000 960 3 1 36 1280x960 70.00 + 1800 1280 112 96 312 126.00 (70Hz) 70.00 + 1000 960 3 1 36 1280x960 75.00 + 1800 1280 112 96 312 135.00 (75Hz) 75.00 + 1000 960 3 1 36 64 + 1688 1280 112 48 248 108 1280x1024VESA-1 024-60Hz 60 + 1066 1024 3 1 38 80 + 1688 1280 144 16 248 135 1280x1024VES[...]

14 Troubleshooting This LCD Monitor has pre-adjusted using factory standard VGA timings. Due to the output timing differences among various VGA cards in the market, users may initial ly experien ce an unstable or unclear displa y whenever a new display mode or new VGA card is selected. Attention This LCD Monitor Supports Multiple VGA Modes. Refer t[...]

15 Product Registration and Technical Support Register Your Planar Products Today Thank you choosing Planar. To assure you receiv e all the benefits of your Planar product and services, re gister your Planar product today. Visit our website to register your product at http://www.planar.com/support /product_registration.html Cables, Replacement Lamp[...]

HDPNRD3700I[...]