SMK-Link VP6700 инструкция обслуживания

Page 1 User’s Manual Rechargeable Wireless Present er Mouse[...]

Page 2 Regulatory Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Certication This equipment has been te[...]

Page 3 Consult the dealer or an experienced radio/TV technician for help. Notice: Any changes or modications not expressly approved by the party responsible for compliance could void the user ’ s authority to operate the equipment. Extension cables are not recommended, if used, they must be shielded in order to comply with the emission limits.[...]

Page 4 System Requirements Hardware: 2 available USB ports Operating System: W indows 2000, XP or V ista Macintosh OS X or above (Mouse Mode fully compatible; F5 and Application Switch in Presenter Mode not supported) Package Contents W ireless presenter mouse Micro USB receiver dongle (stored inside battery compartment) USB charging cable 2 x AAA [...]

Page 5 Open the battery compartment by pressing down the cover latch located at the end of the mouse. Please note that the micro USB receiver dongle also stores in this compartment when traveling. Insert the two supplied AAA rechargeable Ni-MH batteries (included in the package) to the battery slots. Make sure the positive (+) and negative (-) ends[...]

Page 6 Charging the Batteries It’ s recommended that you fully charge the batteries before initial use; nevertheless the mouse is functional anytime during charging. Plug the USB connector of the charging cable (included in the box) into the computer ’ s available USB port. Connect the barrel-tip end of the USB chargimg cable to the mouse’ s [...]

Page 7 of the batteries. The mouse is operational during charging; you can continue use the mouse while charging it via the USB charge cable. The mouse is designed with a sleep mode to save power . When the mouse is inactive for approximately 10 minutes it will automatically shot off the optical sensor . T o wake it up just click on the right- or l[...]

Page 8 Connecting the Mouse to the Computer Retrieve the micro USB receiver dongle stored inside the battery compartment by opening the battery door as shown in Installing the Rechargeable Batteries section. Close the door . Connect the micro USB receiver dongle to an available USB port on your computer . W ait for the computer to go through its de[...]

Page 9 The radio frequency (RF) codes are factory preset for your convenience; the mouse should be functional at this point. If for any reason the mouse does not function correctly , i.e. no cursor movements or sluggish cursor movements, there may be other wireless devices in the vicinity operating in the same radio frequency channel. The mouse can[...]

Page 1 0 Using the Presenter Mouse W orking in mouse mode – the sliding door on the top is closed The mouse functions as a standard 3-button mouse: right click, left click and the scroll wheel as the 3rd button. The mouse goes to sleep mode to save battery power after approximately 10 minutes of inactivity . W ake it up by clicking on any button.[...]

Page 11 W orking in presenter mode – the sliding door in open position Open the sliding door by pressing on the top cover with 2 thumbs and gently glide the door toward the back of the mouse, away from the 2 mouse buttons, until it stops and clicks. Do not force the door open or pulling the door beyond the open position. The presenter automatical[...]

Page 12 Operating T ips & T rouble Shooting Make sure the mouse is turned on by checking the on/off switch located at the bottom of the mouse before using it. Conserve the battery power by switching the on/off switch to “off” position while traveling or if the mouse will not be in use for awhile. If you will not use the mouse for a long per[...]

Page 13 ashing for power-low; and follow the instructions in Charging the Batteries section to rechar ge the batteries. The mouse is functional during char ging. The mouse stays connected to your computer even when it’ s turned off. If for any reason the connection to the system is lost or interference is detected (erratic cursor movements), ?[...]

Page 1 4 either repair or replace it with a more current or upgraded model if the originally purchased model is not available. This warranty does not cover products which have been subjected to misuse, accident, physical damage, improper installation, abnormal operation or handling, neglect, inundation or re, or when product regulatory label has[...]

Page 15 Laser W arning The LASER button located under the sliding door of the presenter mouse activates a laser which emits a red laser beam from the front of the presenter mouse unit. It is typically used as a pointer during presentations. The laser beam emits for the duration that you press the button. Caution Do not stare into laser beam for it [...]

Page 1 6 T hank Y ou Thank you for purchasing the Rechargeable W ireless Presenter Mouse. W e know you had other choices and we appreciate that you chose Interlink Electronics W ireless Presenter Mouse by SMK-LINK for your product needs. So that we may better serve you in the future, please register online at www .smklink.com/register . © 2008 SMK[...]