Zenoah KOMAT'SU HB2302 инструкция обслуживания

GB-1 G B HB2302 / HBZ2601 HB2302 HBZ2601 G B OWNER’S MANUAL BLOWERS[...]

GB-2 HB2302 / HBZ2601 EXPLANA TION OF SYMBOLS AND SAFETY W ARNINGS W ARNING!!! RISK OF D AMA GING HEARING IN NORMAL CONDITIONS OF USE, THIS MACHINE MA Y INVOL VE A DAIL Y LEVEL OF PERSONAL EXPOSURE TO NOISE FOR THE OPERA TOR EQUAL TO OR GREA TER THAN 85 dB(A) SOUND LEVEL VIBRA TION LEVEL ON HANDLE ISO 11094 LwA measured guaranteed ISO 7916 racing M[...]

GB-3 G B HB2302 / HBZ2601 1. Par ts location 1. Stop Switch 2. Throttle Lever 3. Air Intake Screen (Air inlet net) 4. Spark Plug Cap 5. Recoil Starter Knob 6. Air Cleaner 7. Fuel T ank 8. Blower Pipe 9. Screw SAFETY FIRST Instructions contained in war nings within this manual marked with a symbol concern cr itical points which must be taken into co[...]

GB-4 HB2302 / HBZ2601 Model HB2302 HBZ2601 Dimensions (LxWxH) mm 325 x 230 x 360 327 x 268 x 360 Dry weight (w/o tube and nozzle) kg 3.7 3.9 Fuel tank capacity liter 0.75 0.65 Engine T ype Air cooled 2-cycle gasoline engin Displacement cm 3 22.5 25.4 Carburetor Diaphragm type (W albro) Ignition system T .C.I. C.D.I. Spark plug Champion RCJ6Y (noise[...]

GB-5 G B HB2302 / HBZ2601 1. Read this manual carefully until you completely understand and follow all safety and operating instructions. 2. Keep this manual handy so that you may refer to it later when- ever any questions arise. Also note, if you have any questions which cannot be answered herein, contact the dealer fr om whom you purchased the pr[...]

GB-6 HB2302 / HBZ2601 morning or late at night when people might be disturbed. Com- ply with times listed in local ordi- nances. 2. T o reduce sound levels, limit the number of pieces of equipment used at any one time. 3. Operate power blowers at the lowest possible throttle speed to do the job. 4. Check your equipment before op- eration, especiall[...]

GB-7 G B HB2302 / HBZ2601 c) Do not allow bystanders in work area. d) Do not point the blower nozzle in the direction of people or pets. e) Always check to be sure that no debris has been blown onto someone else’ s property . f) Pay attention to the direction of the wind, do not work against the wind. 3. T o minimize blowing time. a) Use rakes an[...]

GB-8 HB2302 / HBZ2601 6. Set up BLOWER PIPE • Align groove in blower pipe with pr ojection on blower housing (or another blower pipe) and slide the pipe onto the blower housing (or another blower pipe). Rotate the pipe clockwise to lock it into place.[...]

GB-9 G B HB2302 / HBZ2601 ■ RECOMMENDED MIXING RA TIO GASOLINE 50 : OIL 1 • Exhaust emission are controlled b y the funda- mental engine parameters and components (eq., carburation, ignition timing and por t timing) with- out addition of an y major hard ware or the intro- duction of an inert material during combustion. • These engines are cer[...]

GB-10 HB2302 / HBZ2601 REST ARTING ENGINE WHILE ENGINE IS HOT 1. When restarting the engine immediately after stop- ping it, leave the choke open. 2. If the engine won’t start after several attempts, close the choke and repeat pulling the r ope or remove the spark plug and dry it. ADJUSTING IDLE SPEED 1. When the engine tends to stop frequently a[...]

GB-11 G B HB2302 / HBZ2601 W ARNING Make sure that the engine has stopped and is cool before performing any ser vice to the blower . Contact with r otating blower fan or hot muffler may r esult in a personal injur y . AIR CLEANER • Never operate the blower without an air filter or with a deformed or broken filter element. • Check the air cleane[...]

GB-12 HB2302 / HBZ2601 • Note that failing to do so may result in the engine catching on fire. IMPOR T ANT • Before starting operation, always make sure to check if the muffler is pr operly held by thr ee bolts to the cyl- inder . (Fastening T orque : 8~12 N·m) • Even if one bolt out of three bolts is loose, the muf fler may get loose during[...]

GB-13 G B HB2302 / HBZ2601 AIR INT AKE SCREEN (AIR INLET NET) IMPOR T ANT •B lowing air is taken in fr om the air inlet net. When air flow has dropped down during operation, stop the engine and inspect the air inlet net for blocking by obstacles. • Note that failure to r emove any such obstacles may r esult in the engine becoming overheated and[...]

GB-14 HB2302 / HBZ2601 2. Align the (5) indicated on the vacuum pipe (4) with the indicated on the blower . Then inser t the vacuum pipe (4) into the blower . 3. T ur n the vacuum pipe (4) until the (5) is aligned with the indicated on the blower to lock the vacuum pipe. W ARNING • Hold the bottom of the vacuum pipe when turning the vacuum pipe t[...]

GB-15 G B HB2302 / HBZ2601 3. Fit the elbow groove with discharge port projection, turn the elbow and mount the dust bag to the main unit. DUST COLLECTING OPERA TION • Put the dust bag belt on the shoulder , and adjust the length of the belt so as to permit easy operation. • Confirm that the dust bag is not twisted, pull the throttle trigger , [...]

GB-16 HB2302 / HBZ2601 Limited warranty Should any failure occur on the pr oduct under normal oper - ating conditions within the applicable warranty period, the failed part will be replaced or repair ed free of charge by a KOMA TSU ZENOAH ® authorized dealer . W ARRANTY PERIOD: 1 year (6 months if used pr ofession- ally , and 30 days if used for r[...]