Hoover U6049 Bedienungsanleitung

’ I HOOVER. Model Owner’s Dial-A-Matic” U6049 Manual Cleaner with Automatic Rd PowerDrive’” 1[...]

Fill in and ret&n! The HOOVER vacuum cleaner you have just purchased is a combination cleaner. The cleaner may be used on carpet and rugs, and it is also for use with attachments. This cleaner is equipped with the automatic ‘Power - Drive’ feature. Your cleaner is a model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .[...]

I Importantsafeguards! II l Read all instructions. ! l Warning: Electric shock could occur if used outdoors or on weh surfaces. I 8 1 l Close supervision is necessary when any appliance is used by or near chil- i{ dren. Do not allow vacuum cleaner to be used as a toy or to run unattend- ,I ed at any time. 1 b l Keep hands, feet, loose clothing, and[...]

MANUAL TRANSPORT BUTTON (DISENGAGE DRIVE) ON/OFF SWITCH COVER LATCH CARRYING HANDLE FULL BAG INDICATOR -SOME MODELS CARPET AND TOOL SUCTION ADJUSTMENT DIAL AND INTERLOCK OPENING FOR CLEANING ATTACHMENTS NOZZLE HOSE FULL BAG INDICATOR -SOME MODELS HEADLIGHT -SOME MODELS ONLY WRAP-AROUND FURNITURE GUARD Warning: Electric shock could occur if used out[...]

Howtouse FIG. 1 This deluxe cleaner provides you with an automatic ‘Power Drive’ feature. It propels the cleaner forward and backward at a variable rate of speed controlled entirely by (you) the operator. ! To move forward Push the handle grip forward. Notice that the clean- er moves in a forward direction with little effort. You control the sp[...]

FIG. 1 FIG. 2 To transport Your ‘Power Drive’ cleaner can be transported by two methods: 1. Use the convenient carrying hand)e for carrying your cleaner up and down stairs or when lifting the cleaner from one surface to another. Lift it as shown in Fig. 1. 2. To roll your cleaner from one room to another, use the convenient button located on to[...]

Cleaning tools 1. Vinyl hose Hose has vinyl jacket for long, trouble-free life. The light flexible hose has a vinyl tab, so it can be hung on the cleaner. A suction regulator is located on the hose grip. 2. Extension wand Use to give extra length when cleaning stairs or above the floor, hard to reach areas. 3. Upholstery brush For upholstered furni[...]

b. To wand Add a tool to the end of the wand by fitting the button projection on the tool into the opening on the wand. You will hear the plastic spring latch snap and lock into place. To release, press down on the spring latch and remove. 4. Remove hose for floor use When you are finished using the attachments, remove the hose. To remove hose from[...]

There are two types of full bag indicators. One is a light which will glow red showing the words “CHECK BAG”. The second is an indicator which appears showing the words “CHECK BAG”. This indicator may become visible for a few seconds when the cleaner is first turned on and will then disappear. If the “CHECK BAG” light stays red, or the [...]

FIG. 1 FIG. 2 outside of cover and the cover is in proper posit&on on the gasket before latching. With the cleaner upright and the handle in the storage position, turn on the motor briefly before lowering handle into cleaning position. This insures that the throw-away bag is inflated. THE SECONDARY FILTER The secondary filter protects the motor[...]

I I i There are two belts on your cleaner. The belts drive the agitator and the power drive pulley and are important for the efficient operation of your cleaner. Because of this, when buying new belts, you should always insist on genuine HOOVER belts. Some other belts on the market, not manufac- tured under the Hoover design and quality controls, m[...]

! Replace agitator and latch it in posi- I tion. (Fig. 4). Make sure that large belt is in center of pulley, and free of agitator mount- ings and latch. Turn agitator by hand to be sure that belt is in proper posi- tion. (Fig. 5). Replace bottom plate. (Fig. 6). Make sure that clips enter into the recesses on the cleaner bottom plate. Check to see [...]

By turning the end plates in opposite directions, one plate will come off. (Fig. 3 and Fig. 4). Then pry out either end section as shown in Fig. 5 and 6. This will ex- pose the shaft. “a-,,, : , , / i Tap the shaft gently with a hammer to release other plate and end section. (Fig. 7). Pull other plate and shaft from agita- tor. (Fig. 8). Remove b[...]

THE HEADLIGHT (Some models only) The headlight, located at the bottom of the front bag cover, operates when the cleaner is turned on. The headlight bulb illuminates both the headlight and the full bag indicator. TO REPLACE BULB 1. Remove cord from electrical outlet. 2. Open rear bag cover. 3. Remove the eight screws from the inside of the front bag[...]

USER CHECK LIST This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem develops, it usually can be remedied quite easily when the cause is identified. Accordingly, this check list is provided for your convenience. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [...]

. VCMA VACUUM CLEAhER MANUFACTURERS ASSOCIATION (HOOVER -AN ASSOCIATION MEMBER) Service To The Consumer Since 19 13 This information has been compiled by the Vacuum Cleaner Manufacturers Associ- ation from Governmental and Private Sources concerned with product safety. These basic guidelines are for your protection and convenience. TO AVOID ELECTRI[...]