Top Innovations SP-350 manual

Built for years o f care-free u se, Read These Instructions completely I before use. MODEL SP-350 Series Please read this m anual before using and keep for future reference.[...]

Professional Style Steamer Dear Consumer Thank you for purchasing t he SteamFast ® Professional Style steamer. In order to prolong th e life of your steamer w e recommend that the water tank be drained between each us e if tap water i s being used. This will reduce liming as a result of hard water. Your SteamFast ® steamer i s equipped with a the[...]

INTRODUCTION Congratulations o n your purchase of th e Steam Fast ® professional Steamer. You will find that the Steam Fast ® is easy to use and extremely versatile. Your new steamer provides professional results every time! 1. Holds over one half gallon o f water - enough for approximately 2. Water container is removable an d easy to fill. 3. Au[...]

IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, always follow basic safety precautions, including the following: 1. Read all instructions. 2. To protect against risk of electrical shock, d o no t pu t appliance in water o r other liquid. 3. Close supervision is necessary when a ny appliance i s used by o r near children. 4. Unplug f[...]

LEARNING ABOUT YOUR STEAMER Please refer to the picture fo r each point (1) The control HANDLE on th e end of the hose sits just before the nozzle. The HANDLE is d esigned to be heat free an d i s safe to grasp. Use the HANDLE to aim t he direction of the steam released from the nozzle. (2) The NOZZLE on the e n d of the handle is l ocated on the e[...]

STEAMER ASSEMBLY STEP 1 - ATTACHING THE ROD A. Se t t h e appliance on a steady surface. B. T h e Rod i s shipped in a collapsed position and must be extended for use. Take the Ro d and loosen the T o p Knurled Knob slightly b y rotating it counter - clockwise. Grab th e Rod by the Hook Mount and extend fully (about 18 inches). Tighten the Top Knur[...]

STEAMER OPERATION A. Set th e unit o n the floor a nd remove the water container. B. Check the inside of the cont ainer the sedime nt . If present rins e th e container and follo w ing the Removing Mineral Buildup procedure found later i n this manual. C. Turn the containe r upside down a n d push the plunger valve open and allow to close tw o or t[...]

PRESSING WITH STEAM 1. Grasp th e control handle with th e nozzle facing upward. Beginning at th e bottom of th e fabric will allow the steam to rise inside an d outside removing wrinkles. Slowly move t he nozzle from t he bottom to t he t o p o f t he fabric. 2. Remove th e nozzle from th e garment and smooth t he fabric with your free hand. NOTE:[...]

Drain the unit b y removing the drain plug (located at the side o f the main unit - see P.4 #1 1). This will allow contents of the reservoir (main unit) t o drain. Tipping the unit in the direction o f th e drain plug to remove any remaining water. Replace the drain plug. Using distilled water will eliminate a residue build up usually found i n tap[...]

OTHER IMPORTANT NOTES During operation t h e steamer hose may gurgle . a. This is a normal result of condensation collecting inside th e hose. Simply lift the control handle upward until the hose is extended t o i t s full height. b. T he gurgling will disappear when t he excess moisture inside the hose has h ad a chance to drain back into the base[...]

TROUBLE SHOOTING THE STEAMER PROBLEM CAUSE SOLUTION Steamer fails to heat Steamer n ot plugged in Plug in to electrical outlet Auto shut off engaged check water container. add water if empty. Reset ON/OFF switch. No steam water level is low Turn ON/OFF switch OFF and refill water container Water drips from nozzle Condensation i n hose Hold the hose[...]

Removing Mineral Buildup One common problem with steamers is mineral buildup caused b y t he high mineral content in many municipal water supplies. Mineral residue inside of the internal pipes and heater can cause intermittent steaming o r i n severe cases n o steaming at all. Th e best w ay t o avoid this is to u se demineralized or distilled wate[...]

Reassembling The Water Tank Valve C a p I f th e plunger becomes separated from t he Valve Cap, follow the following procedure. A . Grab th e Value C a p Assembly and rotate i t counter clockwise about 1/8th of a t urn. Lift straight up t o remove t he cap. T he disk will most likely b e found inside the water container. Carefully drain th e water [...]