Smooth Fitness 9.1 SERIES manuale d’uso

SMOOTH is a registered trademark of InternetFitness.com Mt. Laurel, NJ OWNER’S MANUAL 9.1 SERIES TREADMILL SALES: (800) TREADMILL (800) 873-2364 REPAIR / SERVICE: (800) 258-4555 Ext. 627 / 630[...]

Page 2 Table of Contents Table of Contents 2 Safety Instructions 3 Electrical & Grounding Information 4 Assembly 5 Basic Operating Instructions 7 - 13 Safety Tether 7 Control / Display Panel 8 Basic Operation 9 Operating Features 10 Program Descriptions 12 Programmable Operation 13 Heart Rate Control (HR Models only) 15 - 18 Target Heart Rate 1[...]

Page 3 Important Safety Instructions WARNING! Read all instructions before use. DANGER - To reduce the risk of electric shock disconnect your treadmill from the electrical outlet prior to cleaning and/or service work. WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons, install the treadmill on a flat level surface wit[...]

Page 4 WARNING! 1. NEVER use a ground fault circuit interrupt (GFCI) wall outlet with this treadmill. 2. Route the power cord away from any moving part of the treadmill including the elevation mechanism and transport wheels. 3. NEVER remove any cover without first disconnecting AC power. 4. If voltage varies by ten percent (10%) or more, the perfor[...]

Page 5 Treadmill Assembly Attention! The following instructions are included only as information so that you, the consumer, understand basically how the treadmill is assembled. 1: Remove treadmill from carton. You may pick the rear of the treadmill up and roll it off the packaging. Remove foam padding, wrap, etc. Observe for possible freight damage[...]

Page 6 7. Place the treadmill in operating position. Make certain cables from upper computer do not come in contact with motor fan. Apply AC power. Start the unit and observe belt tracking. Unit must be reasonably level for proper tracking. Test treadmill basic operation. This includes noise, motor performance, etc. 8. Remove (2) black phillips hea[...]

Page 7 NEVER operate this treadmill without reading and completely understanding the results of any operational change you request from the computer. UNDERSTAND that changes in speed and incline do not occur immediately. Set your desired speed on the computer console and release the adjustment key. The computer will obey the command gradually. NEVE[...]

Page 8 Control / Display Panel 1 2 3 4 5 6 7 8 9 10 11 1. Quick Start Instructions. 2. Left hand display window. Dis- plays Incline, Segment, Lap, or Calories depending on mode. 3. Center display window. Used to select or alter programs. In pro- grammed operation, this display graphically illustrates the relative speed and incline for each seg- men[...]

Page 9 Basic Operation DO NOT STAND ON THE WALKING BELT WHILE LEARNING TO OPERATE YOUR NEW TREADMILL!! Optional setup for Calorie Computation and or Countdown Timer 1. Start with the Display unlit. Press [STOP/PAUSE] twice if necessary. 2. Press [ENTER] . The Incline/Segment/Lap/Calorie window will light, showing the current user weight. 3. Press t[...]

Page 10 Operating Features Pause Feature: Workouts may be paused at any time, during either manual or program operation. During a pause, Time and Distance will be held. Speed and Incline may be adjusted while paused. 1. Press [STOP/PAUSE] . The treadbelt slowly decelerates to zero mph. 2. Press [START BELT] to resume workout at previous settings. P[...]

Page 11 Odometer / Hour Meter: When the tether cord is initially placed in operational position the dot matrix window will display HOUR and other windows will indicate total time (hour) of treadmill use. This data will stay on a few seconds and change to an odometer . Display will then blank out. The left hand window indicates upper computer softwa[...]

Page 12 Program Descriptions Speed and Incline Programs All Smooth Programmable treadmills are equipped with eight different programs to add variety to your workout. Each program is evenly divided into 10 equal segments. The workout computer will automatically divide any selected workout time by 10 to give you equal segment lengths. We provide you [...]

Page 13 Note: Refer to instructions on countdown elapsed time feature. All programs have the workout preset at 20 minutes. You may change to another (10 minutes is minimum) if desired by following instructions pertaining to countdown time. This must be done before belt movement is begun. To Select a Program: 1. Begin with the treadbelt stopped. Pre[...]

Page 14 To Review / Change a Program: 1. Begin with the treadbelt stopped. If necessary, press and release the [ST ART BEL T] key to light the display. 2. Press [SELECT] as many times as necessary to toggle the display to the desired program. Note: You may choose to edit either the pre-programmed workouts (first in the displayed series) or the user[...]

Page 15 Target Heart Rate (HR models only) The old motto, “no pain, no gain”, is a myth that has been overpowered by the benefits of exercising comfortably. A great deal of this success has been promoted by the use of heart rate monitors. Many people find their exercise much more enjoyable and effective by maintaining their heart rate in the de[...]

Page 16 Using a Heart Rate Transmitter (HR Models) How to wear your wireless chest strap transmitter: 1. Attach the transmitter to the elastic strap using the locking parts. 2. Adjust the strap as tightly as possible as long as the strap is not too tight to remain comfortable. 3. Position the transmitter with the logo centered in the middle of your[...]

Page 17 Heart Rate Control (HR model only) WARNING! DO NOT USE THE HEART RATE CONTROL PROGRAM IF YOUR HEART RATE IS NOT REGISTERING PROPERLY ON THE TREADMILL’S DISPLAY! Special Operations of Heart Rate Functions: All Smooth treadmills that are factory equipped with a Heart Rate Control system have many distinct features both in the Heart Rate Con[...]

Page 18 Technical Specifications of Heart Rate Control: The protocol for the Heart Rate Control program is: Range of Actual Heart Rate Change in Incline Time Between Changes 11 to 20 Beats Below Target Increase by 1% 15 Seconds 6 to 10 Beats Below Target Increase by 1% 30 Seconds 3 to 5 Beats Below Target Increase by .5% 30 Seconds 2 Beats + Target[...]

Page 19 Note: Enter a countdown elapsed time if desired. 1: Press and release the [START BELT] key. 2: Press and release the [SELECT] key. The first program to be displayed is Heart Rate Control, HRC. HRC will be displayed in the right hand window. 15 will be displayed in the left hand (incline) window. 3: With the [INCLINE +/-] keys adjust to desi[...]

Page 20 General Maintenance Belt and Bed - Your treadmill uses a very high-efficient low-friction bed. Performance is maximized when the bed is kept as clean as possible. Use a soft, damp cloth or paper towel to wipe the edge of the belt and the area between the belt edge and frame. Also reach as far as practical directly under the belt edge. This [...]

Page 21 TREADBELT TRACKING ADJUSTMENT: The performance of your treadmill is dependent on the frame running on a reasonably level surface. If the frame is not level, the front and back roller cannot run parallel, and constant belt adjustment may be necessary. The treadmill is designed to keep the treadbelt reasonably centered while in use. It is nor[...]

Page 22 Service Checklist - Diagnosis Guide Before contacting your dealer for aid, please review the following information. It may save you both time and expense. This list includes common problems that may not be covered under the treadmill’s warranty. PROBLEM SOLUTION/CAUSE Display does not light Treadbelt does not stay centered Treadmill belt [...]

Smooth Treadmills - LIMITED WARRANTY CONSULT YOUR PHYSICIAN BEFORE USING THIS PRODUCT. This Limited Warranty applies in the United States to products manufactured or distributed by Smooth Fitness (“Smooth”) under the SMOOTH brand name. The warranty period to the original purchaser is (lifetime) on the frame, (5) years on the motor, belt, deck a[...]