Tricity Bendix TBG700 manuel d'utilisation

TBG700 User Manual Gas Hob[...]

2 Welcome to the world of Electrolux Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples on the cover in this manual. Please take a few mi[...]

3 Contents Important Safety Information .................................................................................. 4 Instructions for the User .......................................................................................... 8 Description of the Hobs ..................................................................................[...]

4 Important Safety Information Y ou MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 950950 Installation  This appliance must be installed and serviced by a competent person as stated in the Gas Safety (Installation and Use) Regulations Current Editions a[...]

5  Ensure the control knobs are in the ‘OFF’ position when not in use.  When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooking appliance.  Unstable or misshapen pans should not be used on the hob as unstable pans can cause an accident by tipping or spillage.  Never le[...]

6 1 . Hob T op 2. Semi-rapid Burner 3. Triple Crown Burner 4. Rapid Burner 5. Auxiliary Burner 6-10 Control Knobs Description of the Hob 2 1 2 4 5 6 7 8 9 3 10[...]

7 INST ALLA TION Any gas installation must be carried out by a registered competent person, and in accordance with existing rules and regulations. The relevant instructions are to be found in the second section of this manual. Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown. WHEN [...]

8 Operation  Hob burners control knobs The symbols on the knobs mean that :  there is no gas supply there is maximum gas supply there is minimum gas supply Lighting the burners For easier lighting, proceed before putting a pan on the pan support. To light a burner:  push in the relevant control knob and turn it anticlockwise to maximum pos[...]

9 Burner minimum maximum diameter diameter Triple crown 180 mm 260 mm Large (rapid) 180 mm 260 mm Medium (semi-rapid) 120 mm 220 mm Small (auxiliary) 80 mm 160 mm As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering. Use only pans or pots with flat bottom. If you use a saucepan which is smaller th[...]

10 Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply . The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. This appliance cannot be cleaned with steam or with a steam cleaning machine. The Hob T o p Regularly wipe over the ho[...]

11 The Burners The burner caps and crowns can be removed for cleaning. W ash the burners caps and crowns using hot soapy water , and remove marks with a mild paste cleaner . A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove. After cleaning, be sure to wipe dry with a soft cl[...]

12 Something Not Working? If the hob is not working correctly , please carry out the following checks before contacting your local Service Force Centre. SYMPTOM  There is no spark when lighting the gas.  The gas ring burns unevenly . SOLUTION  Check that the unit is plugged in and the electrical supply is switched on.  Check that the RC[...]

13 OVERALL DIMENSIONS Width: 680 mm Depth: 510 mm Height: 72 mm CUT OUT DIMENSIONS Width: 560 mm Depth: 480 mm Thickness: 30 mm SUPPL Y CONNECTIONS Gas: R 1/2 inch (1/2 inch male) Rear right hand corner Electric: 230 V ~ 50 Hz supply , 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse HEA T INPUT Rear Left Burner 2.0[...]

14 Burner Dia. Tap By-pass 1/100 mm Auxiliary 2 8 Semi-rapid 3 2 Rapid 40 Triple crown 5 6 Aeration adjustment none BURNER RAPID SEMI-RAPID AUXILIARY TRIPLECROWN POSITION M A X M I N M A X M I N M A X M I N M A X MI N NOMINAL THERMAL POWER k W 3 .0 0.65 2. 0 0.45 1. 0 0.33 4. 0 1. 2 NOMINAL FLOW RATE m 3 / h 0.286 0.062 0.190 0.043 0.095 0.031 0.38[...]

15 Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.S. 813 Current Editions and the ETCI Rules for Elec[...]

16 CLEARANCES REQUIRED WHEN FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE CLEARANCES REQUIRED WHEN FITTING THE GAS HOB WITH A COOKER HOOD ABOVE Installation IMPORT ANT This hob must be installed by a competent person to the relevant Gas Standards. Any gas installation must be carried out by a registered competent person. Please, ensure that, once[...]

17 It is important to install the elbow correctly , with the shoulder on the end of the thread, fitted to the hob connecting pipe. Failure to ensure the correct assembly will cause leakage of gas. Gas Connection Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or copper . The connection should be suitable for [...]

18 Cut Out Size The dimensions of the cut-out are given in the diagram. 560 480 30 150 min[...]

19 ON/OFF SWITCH FLEX OUTLET 2 Building over a kitchen unit with door Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in diagram 3. The panel fitted under the hob ("a") should be easily rem[...]

20 Fitting the Hob into the Worktop Carry out the building in of the hob as follows: 1. p lace the seals supplied with the hob on the front edge of the cut out. Then, place them at 50 mm from the side edges and at 10 m m fr om th e rear edge, as shown in the diagram, taking care that the seals meet without overlapping. 2. Place the hob in the cut o[...]

21 Electrical Connections Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS HOB MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. This hob is designed to be connected to a 230 V 5[...]

22 Wiring Diagram 2 1 L N 0 220 240 1 2 3 4 5 N Permanent Connection In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current elect[...]

23 Fault Finding Preliminary Electrical Systems Check START Isolate appliance and carry out: A: Earth Continuity check. Has inlet fuse blown? Carry out: C: Polarity check. Electricity supply should now be satisfactory. Carry out: D: Resistance to Earth check. Inlet wiring faulty. Rectify any fault. Isolate appliance and carry out: B: Insulation che[...]

24 A. EARTH CONTINUITY CHECK Appliance must be electrically disconnected - meter set on W (Ohms) x 1 scale and adjust zero if necessary . — T est leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 W (Ohm), check all earth wires for continuity and all contacts clean and tight. B. INSULA TION CHECK Applian[...]

25 Check gas supply at burner Ignition System / Gas Ignition YES Check plug top fuse and replace if necessary Check polarity and earth continuity of supply point Check earth continuity of appliance Ignitor does not spark Check fitting of burners Check position of the electrode Check by pass simmer adjusted Light burner manually Check continuity fro[...]

26 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. T o do this, follow the procedure below . 1) Turn the gas tap to the MAX position and ignite. 2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extinguish[...]

27 Conversion from Natural Gas to LPG IMPORT ANT The replacement/conversion from natural gas to LPG should only be undertaken by a competent person. It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted. The gas rate is adjusted[...]

28 Standard Guarantee Conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour , materials or carriage on condition th[...]

29 Customer Care For general enquiries concerning your Electrolux appliance, or for further information on Electrolux products please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.electrolux.co.uk Customer Care Department Electrolux Major Appliances Addington Way Luton Bedfordshire, LU4[...]

30 This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law. If you move from one of these countries to another of the countries listed below the appliance guarantee will move with you subject to the following qualifications: ?[...]

31[...]

32 35674-6903 02/07 R.0 www .tricity-bendix.co.uk[...]